Pearson Coaster Standard Equipment
Return to Pearson Coaster page
|
Hull, deck, keel and cabin trunk are integrally molded of fiberglass reinforced polyester resin.laminate construction. Coamings and exterior wood trim are natural task, non-skid molded-in surface on deck and cockpit sole. Fiberglass hatches, self bailing cockpit, extra large lazarette hatch and sail locker hatches (P/S) with deep drains. Two deck scuppers, two cockpit sole scuppers and seat scuppers (P/S) Cast lead inside keel completely sealed in fiberglass laminate. Chrome plated bronze, stainless steel, or special marina alloys including special stainless steel sternhead fitting, stainless steel backstay and shroud chain piates, bow chocks (P/S), bow cleat, stern shocks (P/S), stern cleats (P/S), flagpole socket, hand rolls, high cockpit coamings, toe rall and taffrall, four large fixed cabin windows, one opening port and three fixed ports. Mast: Anodized aluminum 6061-T6 alloy with spruce spreaders, rigging fitting of stainless steel and aluminum alloy. Masthead fitting of stainless steel fitted with offset main and jib halyard sheaves. Spinnaker halyard ball and flag halyard eye. Cleats for main, jib and downhaul. Gooseneck track, sail track and track gate. Boom: Anodized aluminum 6061 - T6 alloy with standard gooseneck, Claw outhaul, topping lift fitting and main sheet blocks. Masthead rig. Stainless steel 1x19 construction with swaged Tru-loc and fittings. Turnbuckles on all shrouds and stays. Toggies on headstay and shrouds. Main and jib halyards of stainless steel. 7x19 wire with decron tall. Fresh water tank, 24 gallon capacity located under V-berths, removable, with thru-top fill, vent and supply lines. Electrical wiring: Stranded copper wire with impervious covering, color coded for circuit identification and located high out of bilge area. Is of sufficient size to prevent voltage drops. All circuits protected with fuses, on/off switch for each circuit. Interior: Forward cabin - 2 bulkhead lights. Head - 1 bulkhead light. Main cabin - 2 bulkhead lights. Galley - 1 dome light. 12 Volts system. Navigation P/S running lights, 12 pt. stern light and 20 pt. bow light. Auxiliary power inboard installation on fiberglass beds of 30 HP Universal Atomic Four marine engine, direct drive, including 30 amp. alternator, 2/8" tobin bronze shaft, propeller, water lubricated rubber bearing, water jacketed exhaust line, and engine room exhaust blower. Controls cockpit mounted. Instruments mounted on side of cockpit wall. Interior Dinette arrangement sleeps six; optional standard arrangement sleeps five. Four inches vinyl covered foam mattress, bulkheads covered with attractive high pressure wood grained laminates. Teak trim, vinyl covered hull sides. Hanging lockers, shelves and ample drawer stowage areas. Additional stowage in dinette backrest with attractive sliding panels. Colors and patterns are coordinated for attractive easy to maintain interior décor. Galley: Stainless steel sink and pump, insulated icebox, ample dish and glass storage with attractive sliding panels. Formica counter tops. Head: fully enclosed with separate access from forward and main cabins. Intake and discharge lines fitted with bronze seacocks. Vented loop on discharge. Engine compartment ventilating system with blower. Grounded rigging. Non skid decks. Optional Equipment A wide selection of factory-installed equipment for this boat is available. See Price Sheet for complete details. Prices and Specifications subject to change without notice. |
Coaster | Marina Index | Home |