• One-piece molded reinforced fiberglass laminate (hand lay-up) with integrally bonded bulkheads. 

• Standard hull color white. Other colors optional. 

• Cove stripe; standard colors.

• One-piece molded reinforced fiberglass laminate (hand lay-up) with balsa core for stiffness and insulation. 

• Color and non-skid surfaces molded in. 

• Textured fiberglass full headliner laminated to deck cabin interior surface.

•  Self-bailing cockpit. 

• Cockpit sail lockers (P&S) with molded drain gutters. 

• Lazarette hatch. 

• Fiberglass coamings and winch islands capped in teak with storage alcoves under. 

• Teak handrails. 

• Deck unit mechanically fastened to hull with overlay of fiberglass for complete watertight integrity. 

• Teak toe rail. 

• Choice of standard deck colors.

• 30 H.P. 4-cylinder gas engine 2:1 reduction. 

• 35 amp. alternator. 1" tobin bronze shaft, shaft strut, propeller, and bronze gland stuffing box. 

• Stainless steel waterbox type muffler with steamhose. 

• Controls and instruments inside of cockpit well include shift, throttle, choke, starter button, ammeter, oil pressure, and water temperature. 

• 30 gal. Monel fuel tank with cockpit sole deck plate fill and overboard vent.

•  Shut-off valve, fuel filter, and flexible line.

• Two 20 gal. Fiberglass water tanks located in main cabin under (P&S) berths, with deck fills, vents, and supply lines with shutoff valves. 

• Toilet intake and discharge lines fitted with bronze seacocks. 

• Vented loop on discharge.

• Fused switch panel. Master power switch, 12V 90 AH battery. 

• International navigation lights. 

• Interior cabin lights. 

• Stranded copper wiring with impervious covering, color coded for circuit identification and located high above bilge area. 

• Designed to minimize voltage drops.

• Chrome-plated brass or bronze, stainless steel, and special marine alloys, including custom designed stainless steel stemhead fitting, stainless steel backstay and shroud chainplates. 

• Bow chocks (P&S), bow cleat, stern cleats (P&S), and flagpole socket. 

• Four large fixed ports (main cabin), and 4 small fixed ports. 

• Two small opening ports. 

• Overhead vent hatch in main and forward cabins. 

• Foredeck plate. 

• Stainless steel genoa tracks through bolted on teak batten (P&S). 

• Genoa blocks with track slides. 

• Two primary sheet winches. 

• Main sheet traveler on bridge. 

• Stainless steel bow pulpit and stern rail. 

• Stainless steel stanchions with vinyl-covered stainless steel lifelines. 

• Edson steerer (model 335) with 5" E.S. Ritchie compass (chrome dome head optional). 

• Emergency tiller.

• Mast of anodized aluminum 6061-T6 alloy with internal track section, stepped through the deck. 

• Aluminum spreaders. 

• Custom masthead fitting and stainless steel tangs. 

• Halyard cleats. 

• Two halyard winches. 

• Boom of anodized aluminum 6061-T6 alloy with internal sail track groove. 

• Fixed gooseneck. Internal clew outhaul. 

• Topping lift. 

• Mainsheet and blocks.

• Standing - stainless steel 1 x 19 with truloc swaged end fittings. 

• Forged turnbuckles for headstay, upper and lower shrouds. 

• Toggles on upper-lower shrouds and masthead toggle on headstay.

• Running - main & jib halyards of 7 x 19 stainless steel with spliced Dacron* tails.

•  Braided Dacron* main and genoa sheets. 

• Flag halyards. 

• Two sheet winches (chrome) with cleats.

• Sleeping accommodations for five (six or seven with optional pilot berths).

•  V-berth in forward cabin with drawer and flap stowage under. 

• Bureau with locker and drawer stowage to port. 

• Hanging locker to starboard. 

• Forepeak anchor rode stowage. 

• Translucent hatch overhead forward. 

• Shelf stowage P&S. 

• Hinged door privacy. 

• Toilet room has fiberglass sole and toilet base. 

• Alcoves and sliding door locker outboard. 

• Vanity equipped with stainless steel wash basin, manual F.W. pump, trap linen stowage, and locker under. 

• Mirror with light over. 

• Hinged entry door. 

• Large hanging locker is opposite toilet room. 

• Main cabin has extension transom berths port and starboard. 

• Lockers and bookshelves with upholstered backrests outboard. 

• Foldaway bulkhead mounted table. 

• Bureau with locker and drawer stowage is to starboard forward of berths.

•  Quarter-berth and navigation station (with chart storage) is located aft to port; drawers and locker under. 

• Stowage shelf above quarter-berth. 

• Teak companionway ladder. 

• L-shape galley aft to starboard. 

• Stainless steel galley sink with manual F.W. pump. 

• Large top loading icebox with foam in-place insulation. 

• Three burner alcohol stove with oven, gimballed. 

• Removable countertop unit over. 

• Large sliding door locker outboard of galley countertop. 

• Drawers and locker stowage under. 

• Wet locker and alcohol tank storage opposite galley next to quarter-berth.

• Textured fiberglass sole in both cabins. 

• High pressure laminates on all countertops. 

• Aft cabin face has recessed areas for instrument installations. 

• Main bulkheads are covered with high-pressure laminates (teak veneer optional). 

• Hull sides are covered with veneer genuwall. 

• Standard berth mattresses are 4" foam; fabric covered throughout. 

• Teak trim and joiner work throughout. 

• Choice of contemporary interior décor colors.

• Bonding system incorporates common grounding of chainplates, seacocks, engine and fuel tank. 

• Seacocks or gate valve on thru-hulls. 

• Deck and cockpit areas have molded-in non-skid surfaces. 

• Self-bailing cockpit. Natural and forced draft ventilation of engine compartment in accordance with U.S.C.G. regulations. 

• Manual bilge pump. 

• Life lines. 

• Teak handrails on cabin top.

A wide selection of factory installed equipment is available for this boat. See price sheet for complete details.

*DuPont Registered Trademark

P39 | Marina Index | Members Index | Home