P36 (Old) - Standard Equipment
Return to P36 (Old) page
| HULL One-piece molded reinforced fiberglass laminate (hand lay-up) with integrally bonded bulkheads. Standard hull color white, other colors optional. Cove stripe; standard colors. Boot top and bottom paint. DECK & COCKPIT One-piece molded reinforced fiberglass laminate (hand lay-up) with balsa core for stiffness and insulation. Color and non-skid surfaces molded in. Textured fiberglass full headliner laminated to deck cabin interior surface. Self-bailing cockpit, Cockpit sail lockers (P&S), with molded drain gutters. Lazarette hatch. Fiberglass coamings and winch islands capped in teak with storage alcoves under. Teak handrails. Deck unit mechanically fastened to hull with overlay of fiberglass for complete watertight integrity. Teak toe rail. Choice of standard deck colors. MACHINERY 30 H.P. 4-cylinder 4-cylinder gas engine. Direct drive. 35 amp. alternator 7/8" tobin bronze shaft, shaft strut, propeller, and bronze gland stuffing box. Stainless steel water-box type muffler. Controls and instruments inside of cockpit well include shift, throttle, choke, starter button, ammeter, oil pressure, and water temperature. 20 gal. Monel fuel tank with cockpit sole deck plate fill and overboard vent. Shut-off valve, fuel filter, and flexible fuel line. TANKS & PLUMBING Two 30 gal. fiberglass water tanks located in main cabin under (P&S) berths, with thru-top fills, vents, and supply lines with shutoff valves. Toilet intake and discharge lines fitted with bronze seacocks. Vented loop on discharge. Flush thru hulls. ELECTRICAL Fused switch panel. Master power switch. 12V 90 AH battery. International navigation lights. Interior cabin lights. Stranded copper wiring with impervious covering, color coded for circuit identification and located high above bilge area. Designed to minimize voltage drops. HARDWARE & DECK FITTINGS Chrome-plated brass or bronze, stainless steel, and special marine alloys, including custom designed stainless steel backstay and shroud chainplates. Bow chocks (P&S), bow cleat, stern cleats (P&S), and flagpole socket. Two large fixed ports (main cabin), and 4 small fixed ports. Dorade box with cowl vent over toilet room on portside cabin top. Transparent aluminum overhead hatch in forward cabin. Overhead vent hatch in main cabin. Foredeck plate. Stainless steel genoa tracks through bolted on teak batten (P&S). Genoa blocks with track slides. 2 primary sheet winches. Main sheet traveler on bridge deck. Stainless steel bow pulpit and stern rail. Stainless steel stanchions with vinyl-covered stainless steel lifelines. Edson steerer (model 335) with 5" E.S. Ritchie compass. (Chrome dome head optional.) Emergency tiller. SPARS Mast of protective coated 6061-T6 alloy with internal track section, stepped through the deck. Aluminum spreaders. Custom masthead fitting and stainless steel tangs. Halyard cleats. 2 halyard winches. Boom of anodized aluminum 6061-T6 alloy with internal soil track groove. Fixed gooseneck. Internal clew outhaul with crank mechanism. Topping lift. Mainsheet and blocks. RIGGING Standing - stainless steel 1 X 19 with truloc swaged end fittings. Forged turnbuckles for headstay, backstay, upper and lower shrouds. Toggles on upper-lower shrouds and masthead toggle on headstay. Running - main & jib halyards of 7 x 19 stainless steel with spliced Dacron* tails. Braided Dacron main and genoa sheets. Flag halyards. 2 sheet winches (chrome) with cleats. INTERIOR Sleeping accommodations for six. V-berth in forward cabin with trap stowage under. Bureau with locker and drawer stowage to port. Hanging locker to starboard. Forepeak anchor rode stowage. Transparent hatch overhead forward. Molded-in shelf stowage P&S. Hinged door privacy. Toilet room has fiberglass sole and toilet base. Alcoves and sliding door locker outboard. Vanity equipped with stainless steel wash basin, manual F.W. pump, trap linen stowage, and locker under. Mirror with light over. Hinged entry door. Large hanging locker is opposite toilet room. Main cabin has settee/berth and bookcase with lockers outboard to port. Pilot and pullout transom berth to starboard. Hinged flaps and stowage bins under pilot berth. Bureau with locker and drawer stowage is to starboard forward of berths. Bulkhead mounted folding table with hinged leafs of high-pressure laminate. Quarterberth and navigation station (with chart storage) is located aft to port; drawers and locker under. Outboard stowage shelf above quarterberth. Hinged teak companionway ladder. L-shape galley aft to starboard. Stainless steel galley sink with manual F.W. pump. Large top-loading icebox with foam in-place insulation. 2-burner alcohol stove with oven, gimballed. Removable countertop unit over. Large sliding door locker outboard of galley countertop. Drawers and locker stowage under. Wet locker and alcohol tank storage opposite galley next to quarterberth. Teak handrails overhead. Textured fiberglass sole in both cabins. High pressure laminates in decorator colors on all countertops. Aft cabin face has hinged access panels (P&S) for instrument installations. Main bulkheads are covered with oak patterned high pressure laminates. Hull sides are covered with oak veneer genuwall. Standard berth mattresses are 4" foam; fabric covered throughout. Teak trim and joiner work throughout. Choice of contemporary interior décor colors. SAFETY EQUIPMENT Bonding system incorporates common grounding of chainplates, seacocks, engine and fuel tank. Seacocks or gate valve on thru-hulls. Deck and cockpit areas have molded-in non-skid surfaces. Self-bailing cockpit. Natural and forced draft ventilation of engine compartment in accordance with U.S.C.G. regulations. Manual bilge pump. Life lines. Teak handrails on cabin top. OPTIONAL EQUIPMENT A wide selection of factory installed equipment is available for this boat. See price sheet for complete details. |