• One-piece molded reinforced fiberglass laminate (hand lay-up) with integrally bonded bulkheads. 

• Standard hull color white. Other colors optional. 

• Cover stripe: standard colors.

• One-piece molded reinforced fiberglass laminate (hand lay-up) with balsa core for stiffness and insulation. 

• Color and non-skid surfaces molded in. 

• Textured fiberglass full headliner laminated to deck cabin interior surface. 

• Self-bailing cockpit. 

• Cockpit sail lockers (P&S) with molded drain gutters. 

• Lazarette hatch. 

• Fiberglass sliding companionway hatch. 

• Drop slides. 

• Fiberglass coamings and winch islands capped in teak with storage alcoves under. 

• Teak handrails. 

• Deck unit mechanically fastened to hull with overlay of fiberglass for complete watertight integrity. 

• Teak toe rail. 

• Choice of standard deck colors.

• 30 H.P. 4-cylinder gas engine. 

• Direct drive, 35 amp. alternator. 7/8" tobin bronze shaft, propeller, and bronze gland stuffing box. Stainless steel waterbox type muffler with steamhose. 

• Controls and instruments inside of cockpit well include shift, throttle, choke, starter button, ammeter, oil pressure, and water temperature. 

• 30 gal. Monel fuel tank with cockpit sole deck plate fill and overboard vent. 

• Shut-off valve, fuel filter, and flexible fuel line.

• One 40 gal. Fiberglass water tank located in forepeak with deck fill, vent and supply line with shut-off valve. 

• Toilet intake and discharge lines fitted with bronze seacocks. 

• Vented loop on discharge.

• Fused switch panel. Master power switch. 

• 12V 90AH battery. International navigation lights. Interior cabin lights. 

• Stranded copper wiring with impervious covering, color coded for circuit identification and located high above bilge area. 

• Designed to minimize voltage drops.

• Chrome-plated brass or bronze, stainless steel, and special marine alloys, including custom designed stainless steel stemhead fitting, stainless steel backstay and shroud chainplates. Bow chocks (P&S), bow cleat, stern cleats (P&S), and flagpole socket. 

• Four large fixed ports (main cabin), and 3 small fixed ports and 1 small opening port. Aluminum overhead vent hatch in main and forward cabins. 

• Foredeck plate. 

• Stainless steel genoa tracks through bolted on teak batten (P&S). Genoa blocks with track slides. 2 primary sheet winches. 

• Stainless steel bow pulpit and stern rail. Stainless steel stanchions with vinyl-covered stainless steel lifelines. 

• Edson steerer (Model 335) with 5" E.S. Ritchie compass (pedestal guard). 

• Emergency tiller.

• Most of anadized aluminum 6061-T6 alloy with internal track section. 

• Aluminum spreaders. 

• Custom masthead fitting and stainless steel tangs. 

• Halyard cleats. 

• 2 halyards winches. 

• Boom of anodized aluminum 6061-T6 alloy with internal sail track groove. 

• Fixed gooseneck. 

• Internal clew outhaul. 

• Topping lift. 

• Mainsheet and blocks. 

• Jiffy reefing gear.

RIGGING

• Standing - stainless steel 1 x 19 with truloc swaged end fittings. 

• Forged turnbuckles for headstay, backstay, backstay, upper and lower shrouds. 

• Toggles on upper-lower shrouds and masthead toggle on headstay.

• Running - main & jib halyards of 7 x 19 stainless steel with spliced Dacron* tails. 

• Braided Dacron* main and genoa sheets. 

• Flag halyards, 2 sheet winches (chrome) with cleats.

INTERIOR

• Sleeping accommodations for six. V-berth in forward cabin with drawer and flap stowage under. 

• Bureau with locker and drawer stowage to port. Hanging locker to starboard. 

• Forepeak anchor rode stowage. 

• Aluminum hatch overhead forward. Molded-in shelf stowage (P&S). 

• Sliding door privacy. 

• Toilet room has fiberglass sole and toiletbase. 

• Alcoves and sliding door locker outboard. 

• Vanity equipped with stainless steel wash basin, foot pump, trap linen stowage, and locker under. 

• Mirror with light over. 

• Sliding entry door. 

• Large hanging locker is opposite toilet room. 

• Main cabin has extension transom berth to port which forms a double and pilot and extension transom berths to starboard. 

• Hinged flaps to stowage under berths. 

• Lockers and bookshelves with upholstered backrests outboard to port. 

• Foldaway bulkhead mounted table. 

• Bureau with locker and drawer stowage is to starboard forward of berths. 

• Teak companionway ladder. 

• U-shape galley aft. 

• Stainless steel galley sink with foot pump. 

• Large top-loading icebox with foam in-place insulation. 

• 2-burner alcohol stove with oven, gimballed. 

• Removable countertop unit over. 

• Large sliding door locker outboard of galley countertop. 

• Drawers and locker stowage under.

• Wet locker and alcohol tank storage to starboard away from stove. 

• Textured fiberglass sole in both cabins. 

• High pressure laminates on all countertops. 

• Main bulkheads are covered with high pressure laminates (teak veneer optional). 

• Hull sides are covered with veneer genuwall. 

• Standard berth mattresses are 4" foam; fabric covered throughout. 

• Teak trim and joiner work throughout. 

• Choice of contemporary interior décor colors.

SAFETY EQUIPMENT

• Bonding system incorporates common grounding of chainplates, seacocks, engine and fuel tank. 

• Seacocks or gate valve on thru-hulls. 

• Deck and cockpit areas have molded-in non-skid surfaces. 

• Self-bailing cockpit. 

• Natural and forced draft ventilation of engine compartment in accordance with U.S.C.G. regulations. 

• Manual bilge pump. 

• Life lines. 

• Teak handrails on cabin top. 

• Automatic fuel shut-off valve.

OPTONAL EQUIPMENT: A wide selection of factory installed equipment is available for this boat. See price sheet for complete details.

P35 | Marina Index | Members Index | Home